Installation Of Car Radios – Tips And Tricks

Information around on the car radio installation reasons for a new car radio, there are many. So, for example, not every car driver with the already built-in radio is satisfied after the purchase. Also a faulty unit can, of course, be the cause for a new acquisition. Thanks to the large number of manufacturers, there is a broad and deep assortment. Because the selection may be difficult ever one. However, car radio test reports can be helpful in the decision. If the desired car is found, the next question is: who the good piece now incorporates? Hobbyists with a basic knowledge in the car electrical system can handle this project easily yourself and save additional workshop costs. If a few tips are taken into account, nothing in the way is the hassle-free installation.

Of course the old must first soft tips to develop of a car radio before the new device can be used. So that is the input and expand quickly, the hobby mechanic should be first the right tool lay out. These include not only screwdriver, Terminal and pliers, but also a removal tool for the special pins, which are used as support, as well as theft. Who so does not have a tool, which can either buy one or a workshop looking at least for the expansion. The development work takes only a few minutes and accommodating dealers offer this work free of charge. The battery should be disconnected with tips on how to install of a car radio before it comes to the nitty-gritty, so that there are no short circuits while working.

Now it is to connect all the cables. So-called ISO-connectors are available, this is insert the cable very easily, because only two parts fit together. There are no such connections it is somewhat harder to find out which cable for the power supply is intended. Small tip here: The cable for the power, so the positive pole is always red. The additional installation of an adapter facilitates even wire it all wires. Is advisable in addition with Terminal to connect everything, so the wires really stuck. The use of heat-shrinkable tubing is very useful for the isolation, since these shorts and consequent defective electronics prevent. Once all cables have found their place, a test run should be started if the radio works. Everything runs smoothly, the device already in the drawer can be pushed. This task is actually the lightest, because most radios have been standardized and thus fit in each Bay. Should be something in the way the brackets, so they can be pushed gently with pliers to the page. So the insertion of the radio is much easier. Robin Daniel

This entry was posted in Uncategorized and tagged , . Bookmark the permalink.

Comments are closed.